Articles about cars: auto repair, tips for drivers, descriptions of car models on autoserviceblog.com

Brake system

Replacement of Lifan Solano vacuum amplifier

To replace the vacuum amplifier on Lifan Solano, it is necessary to remove the main brake cylinder with the bacht first. Then do the following: Scrolls the nut of the...

Removal and installation of the master brake cylinder on Mazda 3 (I)

The first step is to drain the brake fluid. Disconnect the brake fluid level sensor connector. Disconnect the brake line and tube from the main brake cylinder. It is also...

Removal and installation of vacuum hoses (brake amplifier) to Mazda 3 (I)

To disconnect the vacuum hose from the brake-side amplifier, press the vacuum hoses on the connectors to connect the vacuum hose to the intake manifold. They need to be removed...

Removing and installing the vacuum amplifier at Mazda 3 (I)

The first thing to do is to remove the battery and its site. After that, remove the main brake cylinder and disconnect the brake line and vacuum hoses

Car body

Installation of rear-view mirrors with Mitsubishi ASX Mitsubishi

The first thing you need to do is twist the bolt in the door to the door, and remove the door cladding, and then pull the cover plate in the...

Replacing the rear court with Mitsubishi ASX

Over time, the rear caretaker on Mitsubiša of the ASH is out of order, and the owner of the car has two ways-to try to "resuscitate" the wiper or to...

External keylock protection under Mitsubishi ASX doorknob

Mitsubishi ASX is equipped with doorknobs "under natural enough", so the handles (holes in the doors) may be scratched from the contact with the fingers and feet

Dismantling of the rear bumper Mitsubishi Lancer 9

The ninth generation of the ninth generation of lancer is pretty easy. The first thing to do is disconnect the power outlet from the rear fog lamp. After that, you...

Steering & Suspension

Replacing the front foot bearings on the Lifan Solano

In order to replace the front steps, the front desk on Lifan Solano performs the following: Take off the turning-sheet. With the lift, remove the bearings ring of the bearing...

Replacement of the Lifan Solano arrowheads

The replacement of the steering gear on Lifane Solano will require the keys to 18, 19 and 21, the key column, and the hinges and pliers. How to do this:...

Replacing the lift bar on the Lifan Solano

To replace the ball support on Lifan Solano, you need keys 17 and 21, and hinges

Replacing the rear dampers on the Lifan Solano

The replacement of the rear shock absorbers on Lifan Solano can be done in this order: Unwind the bottom fastening of the shock absorber (it is desirable for this car...

Electrical equipment

Self-installation of the DHO on the Lifan Solano

For those who want to install daytime running lights on Lifan Solano without inverting the bumper, you can use the following scheme: Buy 5 bright LEDs, resistor 100 Om and...

Types of Lifan Solano lamps

Lamps of the following types shall be installed on Lifan Solano: Front-Headlamp H3, Power 55 Wt.Middle Lamp H1, 55 W

Lifan Solano door trailer is frozen

One of the problems of Lifan Solano is the freezing trailer doors. One way to solve this problem is to install a trailer spring. I'm gonna need a tool and...

Renovation left of Mazda 3 (I)

It is not unusual for the first generation of cold weather cats to stop working on the left side of the curve, and the right is functioning properly. The problem...

Engine

The smell of the rubber band at Mitsubishi Outlander XL

All Mitsubishi Outlander XL owners face this problem. The smell comes from a catalyst. It's because of the moisture that gets on it. Over time, the smell should be gone...

The smell of burning plastics outside the Mitsubishi Outlander XL

The smell of burned plastics can occur at the very beginning of the Mitsubishi Outlander XL. It is believed to be due to a burnout of the coating of the...

Unstable operation of Mitsubishi Pajero 3 engine after repair

Sometimes, after repair work on the engine Mitsubishi Pajero 3, it may start to operate unstable, especially at idling speed. One of the most common causes of this problem is...

Nominal concentration of anti-freeze at Mitsubishi Pajero at different temperatures

For the operation of Mitsubishi Pajero 3 and 4 generations in different climatic conditions a different concentration of the liquid concentration of the coolant DIA QUEEN SUPER LONG COOLANT is...

General Operational Issues

The trailer of which mass can be towed without the effect on the transmission of the Toyota Highlander II

The Toyota Highlander II construction is designed to be towed, but it should be remembered that the benefits of the car would not be clearly beneficial, and should be considered...

The TToyota Highlander II regulation is as follows:-10,000 km/ 12 months.-20000 km/24 months.-30,000 km/36 months.-40,000 km/h and 48 months. With regard to the cost of the course, the sample prices...

Toyota Land Cruiser 200

The main differences of the Toyota Land Cruiser 200 (2012) are:-The new gasoline engine, capacity of 4.6 liter, and the capacity of 309 hp. -The emergence of adaptive Modes for...

Toyota Prius emergency stop

If the Toyota Prius car stop is impossible, it is necessary to put both feet on the brake pedal and push hard. There is no point in letting down and...

Safety

How to program the speed at which the central lock is closed at the beginning of the Skoda Fabia II movement

You will need VAG-COM (VCDS) to manipulate the settings, including the central lock. Even if this program is installed on a laptop, the Skoda Fabia II diagnostic connector will fail...

Problems with Skoda Fabia II central lock

Skoda Fabia II of 2011 often encounters problems with the work of the central castle, due to differences in its design from cars of other issues. The most common problem...

The airbag indicator in Skoda Octavia

If the airbag indicator has caught fire for no apparent reason, it is sometimes helpful to test the connection of the wiring-related chips, to process them with a lubricant for...

Suzuki SX4 Core Access System

The system of unkey access to Suzuki SX4 is stable even in the cold, but if it is very cold outside, it is necessary to hold the finger on the...

Spare Parts & Accessories

Nissan Qashqai II

On all Nissan, the second generation of Nissan put special caps on wheel-bolts to protect them from environmental effects. These caps are removed by means of a special instrument similar...

47. Nissan Qashqai II with engine 1.6 dCi

Salon filter-27277-4BU0A The filler cap of the crankcase is 11026-00QAB Aerial filter-16546-4BA1A

Nissan Qashqai II with engine 2.0

Salon filter-27277-4BU0A Maslyan filter-15208-9F60A filler of crankcase pallet-11026-01M02 Aerial filter-16546-4BA1B Ignition (1 unit)

Where you can make an additional Intelligent Key key for a Nissan Teana

To run a Nissan Tana, you must have the Intelligent Key key registered in the NATS security system. This system allows you to register up to 4 Intelligent Key keys

Technical fluids

Opel Vectra Filling Volume

-Lubrication system (including filter): for engines 1.6-3.5 litres, for motors 1.8 and 2.0 to 4 l.-Cooling system: for engine 1.6 (SOHC)-6.1 litres, for motor 1.6 (DOHC)-6.7 litres, for engine 1.8-7.3...

Which technical liquids are recommended to be poured into the Renault Fluence

Dealers are recommended to use the Glaceol RX Typ D 1l Renault 7711428132. It's produced by Total for Elf. Concentration has a green color and the breeding takes a yellowish...

Technical liquids for Renault Sandero

Reno's general partner is the Elf brand, which is a member of the Total group. Thus, as official technical fluids at the Renault Sandero, the ELF Evolution SXR 5W-30 or...

What anti-freeze is to pour into the Skoda Octavia A4 (Tour) cooling system?

The manufacturer prohibits the use of water (even distilled) in the Octavia cooling system. The use of water is prohibited even in emergency situations. The Cooling System of Octavia Tur...

Transmission

Periodicity of technical servicing of Mitsubishi Pajero 4

The Mizubian Padero Transmission Units need to be serviced at the following frequency:-Oil in a manual gearbox and endbox-check every 15,000 people. In km, every 45,000 people will be replaced...

Transmission problems Mitsubishi Pajero 3

Both automatic and mechanical boxes on Mitsubishi 3 do not create great problems for owners of the car and serve very long under the condition of regular replacement of oil

4x4-drive train modes at Mitsubishi Pajero 4

The Mijubsi Paderio 4 box has 4 operating modes:-2N-rotation is transmitted only to the rear wheels. The mode is intended for traffic on a dry smooth road.

Removing the wadi with Mitsubishi Pajero 4

The procedure for removing the front end of the shaft from Mitsubishi Padero 4 is as follows: 1) Put the lever in position 2H.2. Sour oil from debrief. 3)

Vehicle interior

Can you install a cup holder on the front of the Mercedes E-Class (W212)

In the Mercedes E-class (W212), the beholder panel is not available for all drivers, but it can be installed by purchasing the original panel from another version. The panel will...

The Mercedes-Benz E-Class dashboard (W211) does not work

Many owners of the Mercedes E-Class (W211) face a backlight failure (the backlight may blink or not be lit) and the wrong odometer reading. This is due to the failure...

Does not correspond to the readings of the fuel level in the Mercedes E-Class (W211)

A frequent error in sensor operation is observed after the replacement of the fuel pump at the Mercedes E-Class (W211). After performing this operation, it is necessary to encode the...

Periodically vibrates the brake pedal at the Mercedes E-Class (W211)

The vibration of the brake pedal in the case of Mercedes E-class W211 is connected to the activation of the SBC electric motor, which creates the pressure in the resolution...

Articles about cars