- Details
-
June 09, 2023
-
Written by Jason Hance
Brake amplifier test procedure at Audi 100 4th generation: Turn off the engine. Hold the brake pedal 10 times. Hold the pedal down and start the engine. If the amplifier is, then the pedal must rise a little. If it doesn't happen, we're looking for a possible malfunction.
- Details
-
June 09, 2023
-
Written by Jason Hance
If the Goetz is equipped with drum brakes, the first thing is to press and release the brake 20 times. If the rear of the disc brakes does not do so. Then open the parking brake cover and pull the handbrake on at least 3 times
- Details
-
June 06, 2023
-
Written by Jason Hance
The adjustment of the rear brake disc brakes on the fourth generation of the fourth generation is as follows: Raise the rear end of the car and remove the wheels.
- Details
-
June 03, 2023
-
Written by Jason Hance
In the case of depressurization of the vacuum amplifier on the Aodi of the fourth generation, there may be a distinctive hissing and a problem with the idling speed due to the pump air. The vacuum is simple enough to take out four nuts.
- Details
-
June 02, 2023
-
Written by Jason Hance
Many owners of the Goetz hear a sound under smooth braking at high speed, knocking on the brakes. The source of the knock is the back drums. Usually, the cleaning of the drums is a problem. If the knock is preserved, the drums need to be moved.
- Details
-
May 30, 2023
-
Written by Jason Hance
The replacement procedure for the ABS 100 4th generation 4-generation unit: Lift and remove the wheel. On the back of the body, find the ABS sensor to remove the lower cover of the engine to disconnect the sensor from the sensor. Disconnect the connector and remove the sensor
- Details
-
May 27, 2023
-
Written by Jason Hance
To change the front brake pads on the Audi 100, you need to reduce the wheel and remove the wheel. Disconnect the connector from the sensor and remove it from the bracket. Remove the retention spring of the outer pad
- Details
-
May 26, 2023
-
Written by Jason Hance
The brake pads on Hendai Goetz are changing as they are worn out
- Details
-
May 24, 2023
-
Written by Jason Hance
In order to replace the brake fluid with the Audi 100 4th generation, it will take about 2 liters of new liquid. For starkness, we're pumping out the old liquid out of the water with the syringe. Then immediately fill it with a new liquid
- Details
-
May 20, 2023
-
Written by Jason Hance
To replace the front wheel sensors of the anti-lock systems of the Aodi A4 8 generation, do the following: Raise the vehicle and disconnect the wheel speed sensor connector.