- Details
-
November 21, 2022
-
Written by Jason Hance
The following parameters are available for Jill MK's regular brake discs. The height is 43 mm. The thickness of the disc is 20 mm. The diameter of the disc is 55 mm. The distance between the bolts is 100 mm
- Details
-
November 21, 2022
-
Written by Jason Hance
Many third generation [ [ RX]] owners are surprised that the official dealer is already recommending the replacement of brake discs (sometimes only front, but more often-all)
- Details
-
November 18, 2022
-
Written by Jason Hance
In some cases, the brakes on the soft pedal of Jill MK are caused by a malfunctioning Pumping Procedure
- Details
-
November 14, 2022
-
Written by Jason Hance
The brakes of the Lexus RX are not too powerful, many owners complain about the low performance of the brakes
- Details
-
November 07, 2022
-
Written by Jason Hance
Many third generation RX owners complained that if the car had stood still more than 24 hours after the car wash, the rear brakes were jammed and could not be moved. This is happening not only in the winter but also in the warm season of the year
- Details
-
November 01, 2022
-
Written by Jason Hance
One of the characteristic problems of Lifan Smiley is the acidity of braking suppports, which may cause the brakes to break or not to work well. Correcting the situation in this order: Pull the car up and remove the wheel.
- Details
-
October 25, 2022
-
Written by Jason Hance
To check the wear of brake pads and discs on Lifan Solano, the following reference sizes can be used: Front wheel wheel-thickness of brake disc 25 mm. Minimum acceptable disk thickness 23 mm
- Details
-
October 18, 2022
-
Written by Jason Hance
Control the parking brake on Lifan Solano in this sequence: Pull the lever to the point. There will be six to eight clicks. If the number of clicks is less than/greater than the standard or the handbrake holds the car on the slopes, then it is necessary to regulate it
- Details
-
October 12, 2022
-
Written by Jason Hance
The replacement of the main brake cylinder on Lifan Solano is performed in this order: Disconnect the minutes from the battery.
- Details
-
October 05, 2022
-
Written by Jason Hance
To replace the vacuum amplifier on Lifan Solano, it is necessary to remove the main brake cylinder with the bacht first. Then do the following: Scrolls the nut of the brake hose of the left front wheel to connect it to the interposer