Brake system

If the arm's arm's Opel Astra H lever is too large, the mechanism needs to be adjusted. To do this, press the brake pedal about 20 times. Then, disconnect the handbrake cover, loosening the cable, and raise the lever up

Opel Astra J upports are knocking over the play, which is formed during the operation of the pad. In order to remove the knocking, a spring is needed with hooks at the ends (such springs hold the wheels in drum brakes of Russian production)

Before replacing the brake discs, the vehicle must be brought up and the front wheel removed

Before replacing the expansion unit of the brake system, it is necessary to drain the brake fluid and disconnect the brake fluid level sensor connector. After this, the supply chain can be disconnected (only on vehicles with ICIE) and the tank is removed

To diagnose the operation of the vacuum amplifier of the brakes, it is necessary to have an engine and several times squeeze the brake pedal. Then shut down the engine and start the engine by pressing the brake pedal

In order to replace the front brake disc at Opel Corsa D, the following steps should be taken: remove the associated wheel, remove the brake sub-port and bracket, remove the two bolts of the brake disc attachment, remove the disc by pulling on

Many owners of new cars complain about the creaking and scratches

To adjust the parking brake on the Vector B with drum brakes, you must: (1) Lift the rear of the car and securely hold it.) Release the brake bowler completely and press the brake pedal several times) to remove the handbrake from the passenger compartment.

Setting of the parking brake on the Opel of Vetra with the rear disc brakes is in this order: (1) Lift the rear part of the car and set the rear of the vehicle. 2) Disallow the handbrake and remove it (3) by lifting the adjustment nut to the end of the front cable

To change the GTZ to the Opel Vektra VB, do the following: (1) Unlock of battery 2) Remove the side retainer from the expansion tower and remove the tank lid. 3) Remove the cover of the relay and remove the plume from the ABS