Brake system

The lifespan of brake pads, like fuel consumption, depends on the driving style. The more often the driver pushes the brakes (there are fans off the start and the same stops sharply), the faster the pads

Change the front brake pads at BMW 1 of the first generation in this sequence: Ram the car and remove the wheel. Pull the retention spring on the sub-port. Pull out the wear sensor (only on the left side). If necessary, change the sensor

In order to change the brake disc on BMW 1 generation, the first generation will need a key "on 15", "on 13", "18", "6". The replacement procedure is as follows:

Braking problems may be caused by the defects or faults of the brake discs or the operation of the ACPR during the transition from the second speed to the first

The BMW 3 E90's fuel consumption is reduced by almost 3 percent thanks to this technology, as well as with the movement on inertia and a slowing of fuel consumption

BMW 3 Y46 owners sometimes encounter this situation: a lit hand brake indicator light is activated on the instrument panel (the handbrake itself is naturally not used)

The causes of the braking may be different. Sometimes it is caused by the overhead of the site blocks. A creaking, non-rigid body, whose symptoms are also misused, may be very rarely the cause of the creaking. Can violin brake pads

The ABS, ASC, and "handbrake lights" are often simultaneously activated on the BMW 3 E46 dashboard. This is usually due to the failure of the ABS sensor or the damage to one of the sensors

It is not necessary to change the vacuum amplifier of the brakes on the BMW 3 E46 if it is hit by motor oil, but it will be very difficult to get to it on its own

The front brake pads are changing when the thickness of the lining is less than 2 mm. The procedure is performed as follows: (1) Take off the coll.2) The key "by 14" unwind the sub-port and remove it. 3) Remove the old beads and remove the antioxitic plates from them