- Details
-
February 19, 2023
-
Written by Jason Hance
For automobiles with automatic box, such a sound is an ordinary case. This occurs because the disk torque is available at the same time as the pad is weakened. Thus, this sound is not a signal of any malfunction of the vehicle
- Details
-
February 16, 2023
-
Written by Jason Hance
The resource of the original pad for Lachetti is 30,000 km on average. The number may change depending on the driving style-frequent heavy braking can reduce the headset resource by half. There is no particularity in the procedure for replacing the Laketti pad
- Details
-
February 15, 2023
-
Written by Jason Hance
In addition to the disc, drum brakes can be installed on the rear axle of KIA Spectra (up to 2007). Their aggregate resource is about 100,000. km travelled. Prevention is recommended to be carried out more frequently: it is necessary to monitor the mechanism of the spacer bar
- Details
-
February 13, 2023
-
Written by Jason Hance
Many owners of the Chevrolet Lacetti hear the extraneous sound at the spot, this sound is like a spinning spring. In addition, sometimes a similar "spring-loaded" sound can be heard during the braking of Chevrolet Lactti at low speeds (10 to 40 km/h)
- Details
-
February 09, 2023
-
Written by Jason Hance
The back brake pads on Citroen C4 are recommended to change only in the complex on both wheels. Raise the rear wheel, put emphasis under the front wheel and remove the rear wheel
- Details
-
February 09, 2023
-
Written by Jason Hance
The Skrup in the rear wheel area of KIA Spectra may be due to the lack of manual brake adjustment for the hand brake oxidation. To solve the problem, it is recommended to lube the gel-back mechanism
- Details
-
February 06, 2023
-
Written by Jason Hance
In order to dismantle the brake panel, remove the rear wheels, remove the cylinder and brake pads. Next, disconnect from the point of the brake shield with the spring brake line with the spring
- Details
-
February 03, 2023
-
Written by Jason Hance
To adjust the parking brake, the lever shall be dropped and the parking brake cover removed. The adjustment node is being accessed. The adjustment is done as follows: looses the counterparty and the nut located opposite
- Details
-
February 02, 2023
-
Written by Jason Hance
The most common problem with the sensor (trailer) pedal is the brake pedal problem. Often when setting the alarm, the sensor is simply forgotten to plug in. After you replace it, the system restores the system
- Details
-
January 30, 2023
-
Written by Jason Hance
The first thing to do is to drain the brake fluid from the expansion. Then clear the bolts of the wheel cylinder to the brake shield. Next, remove the brake drum and the spacer bar and lead them away from the cylinder