Brake system

The work must be done on a level platform, without a gradient. First, you need to disable the battery minus the battery and lift the car. The start of the brake system is needed from the air valve, which is furthest from the main brake cylinder.

To check the condition of the brake discs, you will need to lift the car and remove the wheels. Disk units with slightly shades are completely normal

The design of the VAZ-2104/05/07 brakes makes it possible to effectively brake in the standard conditions, that is, when the engine is running. The fact is that the performance of the braking system provides a vacuum amp that operates only when the engine is running

The brakes should be checked on empty empty spaces. Before checking, the ABS should be disabled by removing the safety fuse. The ABS control lamp shall be lit.

The Fordovian emergency braking system is called EBA-Emergency Brake Assist. This system is part of the ESP exchange rate stabilization system. Its sensors measure the speed and braking forces

Replacement of brake pads is a procedure that the owners of the VAZ vehicles prefer to carry out their own hands without recourse to specialists

The brake discs need to be changed in pairs. The first thing is to reduce the car, then remove the safety brackets from the wheel bolts. If they are rusty, it is desirable to replace them. The position of the disc in the hub is desirable to be marked with a marker

The third generation Mondeo brake fluid needs to be changed every two years. About 1.5 l brake fluid is required to fill the entire system. It is important to fill the liquid recommended by the manufacturer

In addition to the front brake pads, it is also necessary to change the back of cars on VAZ vehicles. At the rear of the model (2105, 2106, 2107, 2108, 2109, 21099, 2110, 2111, 2112, 2113, 2114 and 2115, etc.) rear drum brakes are used to switch rear brake pads on them with their hands

The first thing you need to do is remove the car, then remove the safety brackets from the wheel bolts. If you want to replace them with the hardware, you need to mark them with a bullet. After that, the rubber hammer needs to shift the disc from the hub