The adjustment of the rear wheel brake adjustment devices for the fourth generation of the fourth generation shall be carried out as follows: We lift the rear parts of the car and remove the wheel. Pull the car from the front of the car. We push the lever on the ground and move it to the left. If the connector lever is also starting to move, then the adjustment nut of the parking system shall be weakened until both levers are accurate until the lever is fixed. The brake control lever shall be closed down to the point at which the spring is connected. Holding the rail screw with the thin horn. If the engine is switched off, the assistant presses the brake on the brake. The steering wheel is released again. The wheels must be rotated freely.
- We lift the rear end of the car and remove the wheels.
- We're taking the car off the brake.
- Squeeke the parking brake actuation lever on the sub-port and move it to the left. If the spat lever is also beginning to move, then the adjustment nut of the parking system shall be weakened until both levers are accurate to the point.
- The brake control lever shall be closed to the point at which the spring is connected. Hold the rail with the thin, thin horn-key.
- When the engine is powered off, the assistant presses the brake medal twice.
- We're releasing the lever again.
- Checking the wheel alignment shall be free to rotate.
