- Details
-
May 14, 2023
-
Written by Jason Hance
In order to remove the hood and boot of the BMW 5 E60, only a flat, thin-blade screwdriver with a wide "sting" is needed
- Details
-
May 13, 2023
-
Written by Jason Hance
Initially, the KIA Rio III is a plastic protection that only covers the heat sink. Depending on the operating environment, you may be satisfied with the available or additional iron without removing the post
- Details
-
May 13, 2023
-
Written by Jason Hance
BMW 5 E60 can be installed on any of the four doors. In this case, the procedure of replacement is simple: only the lock is changed: the old one is removed and a new lock is put on its place
- Details
-
May 12, 2023
-
Written by Jason Hance
The owners of the BMW 5 E60 have problems with the laying of side mirrors: the driver's mirror is placed in the opposite direction about 180 degrees
- Details
-
May 12, 2023
-
Written by Jason Hance
The following materials and tools are needed to install the protective mesh before the Kia Sorento 2 heat sink: a protective grid, scissors, and a thermogun ("building dryer").After the bumper is removed, the first case needs to be attached to the grid on the grille
- Details
-
May 11, 2023
-
Written by Jason Hance
BMW 5 E60 may make a black metal deflector located at the front of the hatch. To fix this problem, you can bend the deflection unit down and lubricate all connections
- Details
-
May 10, 2023
-
Written by Jason Hance
In fact, the registration of BMW 5 E60 in this case is not particularly difficult. Main, when painting the car, leave special stickers and VIN plates intact
- Details
-
May 10, 2023
-
Written by Jason Hance
The headlight washer in KIA Sorento II is automatically working with each of the fifth activation of the windshield washer. Detach it, as in most other cars, removing the safety fuse, will not work. The thing is, this fuse is not just a headlight.
- Details
-
May 09, 2023
-
Written by Jason Hance
There are two problems: adjusting the height of the rubber bands on the sides of the trunk lid; adjusting the position of the lock bracket
- Details
-
May 09, 2023
-
Written by Jason Hance
The problem is typical of new cars. In time, the tight locks are working, and the doors will be closed normally