- Details
-
February 09, 2023
-
Written by Jason Hance
None of the items in the Necia are equipped with a rain sensor, but you can install it yourself. For this purpose it is necessary to purchase a universal set of rain sensor, which will also be suitable for other models of cars (specify compatibility with the seller)
- Details
-
February 08, 2023
-
Written by Jason Hance
The first thing to do is to dismantle the dashboard and find the food for the tachometer (for example, from hours).In order to receive a signal with engine speed information, connect to the left connector on the instrument panel to the 15th contact
- Details
-
February 08, 2023
-
Written by Jason Hance
To replace the lamp in the additional stop lamp Keia Serato 2, you need to open the trunk, find the human in the passenger's stop-signal located in the passenger compartment and turn the stop lamp out counterclockwise.
- Details
-
February 08, 2023
-
Written by Jason Hance
The salon of the salon in the Necsias light illuminates the salon rather loosely. You can replace the lamp with the LED or just have a little rework of the fon. It will be necessary to produce a reflective reflector (not available in the Necsiah flame.)
- Details
-
February 07, 2023
-
Written by Jason Hance
The main reason for the diversion of water to the front fog lamps of the Daewoo Nexia is the wires that go to the anti-manneric. This thafra has a longitudinal incision, so water goes in there. Gofram needs to be replaced or simply wrapped around the thick layer of the tape
- Details
-
February 07, 2023
-
Written by Jason Hance
To replace the backlighting lamp with the Kiia Serato 2, you first need to remove the backlight (s) with a flat-blade screwdriver. After that, you must remove the plafers by turning them counterclockwise and pulling them down. After that, new lamps need to be installed
- Details
-
February 07, 2023
-
Written by Jason Hance
In order to replace the lamps in the case of Nexia, the plastic cover shall be checked counterclockwise and removed from the headlamp. Then, disconnect the power connector from the headlight and then click the spring pressure retaining clip and pull it out.
- Details
-
February 06, 2023
-
Written by Jason Hance
There is no "pit" or "no hole" in the non-"pit". It is easiest to remove the fog lamp before replacing the lamp. To access the lamp, remove the cover and remove the plate.
- Details
-
February 06, 2023
-
Written by Jason Hance
The owners of the KIA Serato 2nd generation car owners periodically encounter problems with the electro. One of the most common complaints of KIA Cerato II owners-short blinking or decreasing the brightness of the headlamps when the ABS or anti-shoe system has operated
- Details
-
February 05, 2023
-
Written by Jason Hance
Necsiah often conjecture headlamps and rear lights after a rain or a wash. This is most likely to suggest that the headlamp is not hermetically sealed. Carefully dry before sealing, otherwise the moisture will remain inside the debt