- Details
-
June 10, 2023
-
Written by Jason Hance
To replace the highlighting in the fourth generation Audi-proofing reader, do the following: Remove the proofreader button. It is difficult to disconnect, so you need to put some feelers out. You can use a thin screwdriver or make the proofreader case
- Details
-
June 09, 2023
-
Written by Jason Hance
You don't have to do that. Hyundai ix35 has a system of energy saving. When the engine is switched off, the headlamps shall be automatically switched off in 1 to 2 minutes. The audio-navigation system is disabled in 5 minutes
- Details
-
June 09, 2023
-
Written by Jason Hance
In order to install the original front fog lamps on the Audi 100 C4, it is necessary to purchase the headlamp itself (code 4AO 941699 and 4AO 941700), another bar with orifice openings (4AO 853683F and 4AO 853684A), relay of the anti-maniac counter (141951253V), switch on the dashboard (893941535), connectors (1 unit)
- Details
-
June 08, 2023
-
Written by Jason Hance
The audi 100 P4 switches are combined into one unit so that they can only be replaced in a collection. To do this: Remove the rudder (if the airbag is fitted with the necessary precautions)
- Details
-
June 08, 2023
-
Written by Jason Hance
It is necessary to check whether the cameras are not activated at the same time as the Hyundai ix35 reversing lamps are not switched on. If the lights are working and the camera is not present, it may be a failure of the end switch
- Details
-
June 08, 2023
-
Written by Jason Hance
The replacement of the lamps in the front fog lamps of the Audi 100 P4 is as follows: Remove the panel on the bumper by the front of the counter. We wind up two screws. We twirl two rotors and remove the back cover. Pull the lamp.
- Details
-
June 07, 2023
-
Written by Jason Hance
In order to replace the glazing of the front fog lamp, the Aodi 100 4th generation will need a flat-shaped and flat-blade screwdriver, new glass and a seal. We work in this sequence: Scrolling down the "recling" at the bottom of the headlight. Disconnect the connectors. Disconnect 4 samorese and remove the headlamp.
- Details
-
June 07, 2023
-
Written by Jason Hance
Dismantling the radiator grate, which must be carried out very carefully, allows you to open the hood and access the battery to recharge it or replace it
- Details
-
June 07, 2023
-
Written by Jason Hance
The Vibration of the Aodi A4 3rd generation engine idling is often associated with an incorrect speed setting
- Details
-
June 06, 2023
-
Written by Jason Hance
You must use a VAG COM adapter in order to encode the control units in the 4th generation AD A4. We go to the main window of the program and select the system we need. Then select the Coding-07 button and press the long encoding