To install omelita'lama ' it is necessary to purchase a set of an omizer kit that consists of covers, trout, motor, sensor, hose, anchorages, and wiring. You also need to buy extra hoses, longer staff (the length may not be sufficient when installing a new bachka).
In addition, the tank of the washer needs to be replaced. The one that is needed is larger and has holes to install the sensor and the engine.
The first thing to do is to remove the bumper and find the markup from the inside to cut the holes in the washer. You can cut the holes with a sharp knife or drill a drill and align it with a file.
Then we need to remove the wheel from the side of the tank, remove the cover and dismantle the tank by turning off the wiring from it. Next, we need to drain the rest of the cleaning fluid in the water and remove the motor from the bachka. Then you can install the engine, the sensor, and the wiring for the new bock and install the tank car itself.
Now you can install the nozzle. They are attached to the regular seats on the television. They will not be confused, they are signed-left and right. After installation, you can pull the hoses from the nozzles to the beachline. When all is installed, you can place the covers, the wheel, and the bumper. The final touches are the installation of the covers on the nozzle.
After the car has been assembled, it is necessary to update the firmware on the official dealer to enable the function of the lamp-maker.