To replace the lambda probe on Suzuki Swift II, it is necessary to disconnect the JSCB. Next, find the lambda probe, cut the connector so that the connector is longer than 20 cm. Next, roll out the old lambda probe and install a new one, pre-cleaning the wires. It is very important not to damage the wires from the lambda probe during the installation. Clear the wiring in the connector and connect all of the walkers in the bundle. Isolate the wires after the connection. Next, connect the prepared Lambda-Probe plug-in, connect the KBs and make a car. To replace the lambda probe on Suzuki Swift II, the equivalent of the BOSCH LS-07.




Add comment

Security code
Refresh