You'd think it might be hard to get a car? However, this simple procedure at first glance is very important for the "health" of the engine. When asked, "How do I get a car right?" sometimes even experienced drivers are unable to answer. How do I get a car with a mechanic?

How do I get a car with a mechanic?

If you have a mechanical checkpoint, the engine start rules are as follows:

  • Monitor the gear lever in neutral position.
  • Before you start a car with the ICPC, put it on the handbrake or squeeze the brake pedal.
  • To make it easier to start the engine, it is better to squeeze the clutch pedal (there are machines that do not get clutch in the clutch at all),
  • Turn the key in the ignition locking system clockwise into ACC (II) position. The ignition will be on and the indicators on the dashboard will be lit.
  • Wait until the indicators go out (usually three to five seconds), and then pivot the key to the next position to start the starter.
  • To run the correct starter 3-5 seconds, if the engine does not start during this time, return the key to the starting position, wait a minute, and try again.
  • Depending on the conditions under which you are driving, the engine can be warmed up.

How do I get a car with a carburetor right?

Carbusts have their own peculiarity in starting the engine: if you want to start the engine on a cold, before turning the key in the ignition, one or two times press the gas pedal. At this point, a carburettor is closed, and a small amount of fuel comes into the engine. However, if after several gas-pedals, the engine has not started, it should not be overzealing; otherwise, there is a risk of just flooding the engine. There is no need to press the gas pedal for the hot gas pedal at the start of the test engine.

Some carburetts (for example, VAZ or old carbusts) have a suction handle, which is a carburetor handle. With this handle, the ratio of petrol to air in the fuel-air mixture can be regulated. In cold weather, at the start of the engine, the engine pump shall be removed and the engine dripping back as the engine progreses. In the warm weather, the pump must be pulled out, and in the heat they might not be used at all.

How do you get a car with a machine gun?

The procedure for starting an engine in a car with an ACPR is as follows:

  • Verify that the machine selector is in the "Parking" (P) or "Neutral" (N) position.
  • Press the brake pedal and hold it while the engine starts.
  • Insert a key into the ignition switch and turn it clockwise to enable the ignition. As soon as the self-diagnosis of the dashboard is finished and all the lights go out, turn the key further to start the engine. If the launch did not occur within 3-5 seconds, return the key to its original position, wait a minute, and try again.
  • If necessary, warm the engine and the ACPU after launch.

How do I get a car with a Start/Stop Engine?

Many drivers who, instead of a conventional ignition lock, see the Start/Stop Engine button in the car for the first time, are confused and can't figure out how to start the engine.

In fact, it's very simple: to start the engine, you have to press the brake pedal and then press the Start/Stop Engine button. If you press the button without pressing the brake pedal, the ignition is on, but the machine will not start.




Add comment

Security code
Refresh