Engine

The first thing to do is remove the fuse #12 from the subassembly unit so that the gas pump is switched off. After that, the car must be started and waited until it snagts. This prevents the flow of gasoline from being replaced when the filter is replaced

When liquid leaks from the water pump, Lifan Smiley will have to be removed and inspected. The order of the works is: Sour antifreeze. Take the belt of the generator and the water pump. Remove the cover of the HBCD. Unwind 6 bolts and remove the top of the EMG-belt

The key on the 7 key is to unscrew the air filter cover, which is located in the lower right side of the engine compartment. Then we can get the air filter out of the plastic box. You can also replace the empty box in the lower left

During the replacement of the gas-distribution mechanism, it is necessary to replace a number of parts. First, it is desirable to replace all auxiliary assemblies because their service life is approximately equal to the length of the GRM-belt service

Motor Lifan Smiley is made on the basis of the Toyota 5A-FE engine, so it has a good reliability. The biggest problems with it are electrical connectors. For example, many cars are stopped by the engine due to the retired starter contact

The Fusion number is located on the cylinder block adjacent to the gearbox. You need to look at the front left with respect to the heat sink. The number is low enough, so you have to stretch. If you face the car, the number will be on the right.

The most likely result is the work of the starter, namely, the slow starter retreat of the starter wheel of the wheel. There could be two reasons. The first is the thickening of the oil from the cold and the second is the pollution of the starter

The burndown of the catalytic manifold (a node that combines the exhaust manifold and catalyst functions on Lifan Smiley) with a disagreeating sound in the engine compartment, similar to the sound of the burning silencer

Sometimes Fusion doesn't have a "spin" starter in the cold when you try to start a motor in the cold. The problem is, the Bendix doesn't want to be coupled with the flywheel. To solve this problem, you have to get to the starter.

For the Fusion engine to be driven into severe frosts, it is necessary to follow the recommendations specified in the operating manual