Engine

The removal of water from the diesel fuel filter of the 4th generation of 4th generation is performed every 5,000. The filter is replaced by 30 thousand kilometers. km Work order: Substitue a small tank with a fuel filter.

There are several versions of the reasons for the emergence of a [ [ sound sound]] under the bottom of KIA Rio III

For the 104th generation of the 4th generation, multi-point injector injectors shall be removed as follows: Vacuum hoser amplifier tubes are removed from the exhaust manifold.

Change the oil and oil filter on the Studio 100 of the 4th generation in such a sequence. Capacity-about 5 litres

Because holes in the KIA Rio III grill are large, many owners protect the radiator with an additional grid. It saves both insects and small stones. There are no problems with overheating the heat sink

The procedure to replace OLM with a 104th generation Audi (running on cold engine): Unwind the expansion box cover. Ran engine protection. Let' s put it under the motor. Unwind the filler cap or remove the lower radiator hose

Change the belt of the gas distribution mechanism in this sequence: Put the piston of the first cylinder in the upper dead point. We're removing the blade belts. Six-hedron looses and withdraws the bolts of the wheel of the shaft. Remove the skin of the serrated belt

When the KIA Rio III engine out of the hood is jammating, a few seconds later, three clicks. The sound produces a throttle control that is used for verification by the sensor to the maximum open and closed position

As the original air flow meter on the Aodi 104th generation with the AVI engine is expensive enough, it can be replaced with the Volga equivalent. For this, purchase the flow-meter under the number 20

Change the spark plugs on the Adi 100 4th generation in this sequence: Scrolls the old candles and inspect the old candles to evaluate the state of each cylinder