Steering & Suspension

First, we need to weigh the front wheels of the car. You can use 2 jacks to do this. Then we need to open the hood and pump all the fluid from the water-amplifier by using the syringe

The size of the Hyundai ix35 is 180 mm. There are various ways to increase it. For example, you can purchase NDRs for the back springs from polyurethane (polyurethane), which will give a sizeable raise of 30 to 40 mm. 50,000 rubles ($1,200 to $1,000-11,500).

Opinions about whether to change rubber sainting blocks to polyurethane, are divided. Some believe that if the polyurethane is properly used in the suspension, Hyundai ix35 will last longer than rubber, but only if an amateur buys quality products

Eating back springs is one of the common complaints of the owners of the Korean crossover. Many of them are becoming obvious after a year of active operation of the car. In this case, it would be useful to replace the springtime springs.

Hyundai ix35 owners ' problem is a common problem in the rear suspension, judging from the feedback in the forums. It is often manifested after 17-20 thousand km of mileage

Some owners of the movement start hearing a dull, unpleasant sound of friction coming from under the hood. Especially well he can hear it, if you let go of the pedal of gas.

One of the weak points of the front suspension of Hyundai Santa Fe II is the shock absorbers. The reason lies in their weak fitness for heavy power units. As a witness, the cushioning racks are able to withstand nearly 50 thousand tons of cushioning. km

In the past, the parts of the rear suspension of Hyundai, Santa Fe II, are out of line and the stabilizer stabilizers-the frequency of the replacement is 20 ,000-30, 000. km The shock absorbers have also not served for a very long time and need to be replaced by about 60,000 people. km

The removal of the excess play in the Audi 100 P4 steering mechanism can be done by using the following procedure: Wheel directly.

The seat belt drive of the hydraulic amplifier on Santa Fe (2.0 and 2.4) shall be as follows: (1) The belt shall be checked correctly by checking the belt-its teeth are to be accurately located in the shea.2) Attach a 100 N (10 kg) force to the back side of the belt between the two pullees