- Details
-
December 04, 2022
-
Written by Jason Hance
The procedure for replacing the site blocks of the rear beam on Jill Cil: Put the car on a hole or a lift.
- Details
-
December 03, 2022
-
Written by Jason Hance
There may be more than one reason for a button failure. The first probable cause is a failure of the spiral contact within the middle part of the steering wheel
- Details
-
December 03, 2022
-
Written by Jason Hance
The procedure for replacing the rear shock absorbers on Jill's MK is: 1. This includes the first gear and the front wheels of the chutme.2 Take off the back of the wheel. Put a suitable support behind the back beam and load the padders.
- Details
-
December 01, 2022
-
Written by Jason Hance
One of the constructional features of Jill MK is a rather weak rear suspension. When a large load of cars starts to come, knocking at the time of the roughness
- Details
-
November 30, 2022
-
Written by Jason Hance
This is a problem that many second generation RX owners have encountered. When the indicator is switched ON, the actuation stops and freezes in one of the positions and the position of the rear axle may be different from the position of the front axle
- Details
-
November 30, 2022
-
Written by Jason Hance
The springs from different cars are suitable for the Hover, it is necessary to choose the most advantageous variant. The characteristics of the springs are: diameter of duck 13 mm. Diameter is internal 100-104 mm. The outer diameter is 130 mm. Height without 390 mm load. Number of turns 6
- Details
-
November 28, 2022
-
Written by Jason Hance
The adjustment node is on the left side of the gear rack. It will require a pit or an overpass (ideally a lift), a hammer, a hammer, a hammer and a hexagonal key on 24
- Details
-
November 27, 2022
-
Written by Jason Hance
On the third generation of the Lexus RX, it is impossible to buy original steering traction because they are simply not produced. It is only possible to replace them with the steering gear, the price of which varies from 40 to 90,000 rubles
- Details
-
November 27, 2022
-
Written by Jason Hance
The first thing to do is to remove the six bolts at the hub, remove the cover and the retaining ring and the gear torque that transmits the torque from the wheel to the wheel. Then it is necessary to roll four bolts of the ball support, unbutton the upper ball, and then remove the lower steering gear and the ABS sensor.
- Details
-
November 25, 2022
-
Written by Jason Hance
When selecting non-original wheel disks, it is necessary to bear in mind that the front hub of Hover will be mounted with discs which have at least 85 mm from the side of the hood of the hub to the top of the cap.