Steering & Suspension

Dust for external ShRUs, original and analogues for Hyundai Tucson

Dust for external ShRUs, original and analogues for Hyundai Tucson
It is easiest to find a suitable SchRUC duster from another car, taking the old one. There is information on the use of duster from Hyundai Elantra, Santa Fe and Mazda 626

What is the reason for the hiss (creak) of the GRU with full rudder at Chery Bonus?

What is the reason for the hiss (creak) of the GRU with full rudder at Chery Bonus?
The swirl or creak of the full rudder turns to the right or to the left arises from the tensioning of the drive belt (hydraulic) steering pump. The problem is solved by adjusting the tensioning of the belt as follows: 1

Dismantling of the steering column at Chery Tiggo

Dismantling of the steering column at Chery Tiggo
To remove the steering column from the Chery Tiggo it is necessary to remove the steering wheel. Align the upper and lower retaining screws of the steering column. Remove the intermediate shaft nut connected to the steering transmission

Wheel wheels after Infiniti FX50 (2gen) (Infiniti QX70)

Wheel wheels after Infiniti FX50 (2gen) (Infiniti QX70)
Many owners of Infiniti FX50 (Infiniti QX70) encounter that after a full stop, even after turning off the ignition, the wheels are starting to pull forward and the body is vibrating

Dismantling of the steering gear racks in Chery Tiggo

Dismantling of the steering gear racks in Chery Tiggo
Before starting the removal of the steering gear, it is necessary to drain the entire fluid from the steering system. Then it will be necessary to install the car on the "hole" or lift it on the lift

Part numbers to replace the front shock absorbers at Chery Tiggo

Part numbers to replace the front shock absorbers at Chery Tiggo
T11-2901110 or Feb. TSS-043 front shock absorber TSS-043 (many defective parts must be thoroughly checked before purchase)

Lexus RX III Lexus III resource

Lexus RX III Lexus III resource
The front cushioning racks on the third generation Lexus RX are out of order before the back. Sometimes a failure is accompanied by a sound or a leak, sometimes the racks simply stop dumping roughness properly

Charges and details for Chery Tiggo

Charges and details for Chery Tiggo
Factory drives R16 × 7 5 × 114.1 EET40-45wheel stiletto Toyota 90942-02049 (2.0 4 × 2 MT) R16, step 1.5 mm tires recommended by the plant: 235/60 R16 or 215/70 R16Podthork: DAC 42800045 (2.0 4 × 2 MT) Opora of the front rack: Toyota 48609-42012, SNR KB669

Inspection of Chery Tiggo Liquid Level Fluid Level

Inspection of Chery Tiggo Liquid Level Fluid Level
To check the amount of liquid in the GRM system at Chery Tiggo, it is necessary to put the car on a smooth platform without a gradient and start the engine

Road traffic adjustment modes on the Jeep Grand Cherokee WK2

Road traffic adjustment modes on the Jeep Grand Cherokee WK2
The pneumatic suspension on the Jeep Grand Cherokee WK2 may adjust the height of the ground clearance. Manual alignment has five modes: Normal Modes (NRH)-used for normal driving conditions. Off-road mode 1 (Off-Road 1)-used at speeds up to 80 km/h