Replacement of the GTP hose on the Audi 100 C4 2.8

To replace the hoses with a hydro-amplifier with a fourth generation Aodi with a motor of 2.8 liters, you need to: Remove the plastic cover of the engine. Remove the hose. Shrink the hose at the upper end of the hose. Connect the main brake cylinder from the vacuum amp. Remove the vacuum amplifier (it is difficult enough to remove the crates under the handlebars).Attach the hose to the rack to attach the hose to the gear rack. It is important not to lose 2 copper washers. Remove the old hose and install a new.Check to ensure that the hose does not lose the helmsman's power.

1. Remove the plastic cover of the engine.
2. Take off the air-creed.
3. Hose the hose from the GD.
4. Roll one end of the hose.
5. Disconnect the main brake cylinder from the vacuum amplifier.
6. Remove the vacuum amplifier (it is difficult to remove because it is necessary to remove the box under the handlebars).
7. Attach the hose to the rack to attach the hose to the gear rack. It is important not to lose 2 copper washers.
8. Remove the old hose and install a new hose.
9. Check that the hoses don't lose the steering traction.
10. Set it all back.
11. Dole the fluid and pump the hydro-amp.

Add comment