- Details
-
February 15, 2023
-
Written by Jason Hance
In order to replace the oil in the manual gearbox, Fujna will need a "pit" or a lift. There's a plastic box on the engine on the left side. You need to remove the cover that's holding on to the latch.
- Details
-
February 14, 2023
-
Written by Jason Hance
"Manual" automatic transmission mode is not entirely complete. When the lever is put into the "±" zone, the number 4 appears in the window, which indicates that the range is 1 through 4, the box now works in it
- Details
-
February 13, 2023
-
Written by Jason Hance
To test the adhesion of a Ford Mondeo III, it is necessary to put the car on the handbrake and start the engine. Then activate the clutch, install the third gear, and start moving.
- Details
-
February 12, 2023
-
Written by Jason Hance
The types and causes of the noise in the Ford Mondeo III:Latrines are signals about worn out gears or bearings. In the MT-75 checkpoint, such noises may occur after the mileage of 200,000 kilometres
- Details
-
February 10, 2023
-
Written by Jason Hance
According to the manufacturer's recommendations, Lifan Smiley is required to switch gear at these speeds: From 1 to 2 at 25 km/h.C 2-at 40 km/h.C 3-at 60 km/h.C 4-5-at 90 km/h.
- Details
-
February 10, 2023
-
Written by Jason Hance
PowerShift is a quotient of two clutches, and it has the same problems as other producers: jerks, twitches, "thoughtfulness". Generally, it helps to replace the oil in the box
- Details
-
February 08, 2023
-
Written by Jason Hance
In order not to overload the engine and the mechanical box of Jill MC, it is necessary to switch gear at optimum speed. To do this, it is possible to stick to this rule: For models with engine 1.3 l :C 1 on 2, or vice versa, switching at 24 km/h
- Details
-
February 07, 2023
-
Written by Jason Hance
If the clutch of Lifan Smiley becomes too soft, or the clutch itself begins to "weigh", first the tightness of the drive train system should be checked. To do this, we push the pedal approximately 60 to 100 times until it becomes elastic.
- Details
-
February 06, 2023
-
Written by Jason Hance
All of Jill MK, 1.3, 1.5 and 1.6 liters, is installed the same clutch actuator. The following defects must be checked and corrected for clutch dispositions: Adherence to the clutch of the clutch pedal
- Details
-
February 04, 2023
-
Written by Jason Hance
The joints of equal angular speed joints on Jill MC manifests itself as follows: Vibration when moving.