To replace the pads, you need to lift the car with a jack and add a spare wheel or wooden bars to the threshold so that the car does not fall if it does not hold the jack. After that, you have to remove the wheel. Then remove the brake sub-port by removing the two bolts located on its inner part (closer to the engine compartment). Once the brake disc has been removed, the brake disc shall be easily removed from the hub. Then, use a screwdriver to pull out the outer pad (it needs to be attached) and then press the inside out on the outside of the sub-port and pull it out. Once the new shoes are installed, everything is collected without any problems in reverse order. It is necessary to start moving with new beads neatly and slow down in advance, as the pad will take some time on the tipor.
