- Details
-
July 03, 2022
-
Written by Jason Hance
All the manual gearboxes on the Opel Vectra V are versions of one 5-step aggregate. It was also equipped with an automatic 4-speed box. Mechanical boxes are very reliable and do not have any weak points, except for the leak of the salamist
- Details
-
June 30, 2022
-
Written by Jason Hance
The adjustment of the transmission of the mechanical transmission to the Opel Vector B shall be carried out in the following sequence: 1) A lighting nut bolt, which attaches the rod-switch gear rod
- Details
-
June 26, 2022
-
Written by Jason Hance
To adjust the transmission of the IBC to the Opel Vektra C: (1) Remove the plastic frame and release the lever on top 2)
- Details
-
June 23, 2022
-
Written by Jason Hance
Procedure to replace the oil in the automatic box Opel Vektra C: 1) Install the car on a flat ground and bet on the engine .2) When the engine is running, press the brake and switch the selector lever over all ranges. (3) Stretting lever in position P
- Details
-
June 19, 2022
-
Written by Jason Hance
The reason for the fact that Peugeot 206 has ceased to be transferred to the Peugeot 206 is the gearshift gears. As a result of wear, the bolt can be broken by which the fox is attached to the box
- Details
-
June 15, 2022
-
Written by Jason Hance
The automatic gearbox installed on Peugeot 206 has three modes of operation: economy, sport, and winter. The economy is a standard mode in which transmission operates at small speeds. This saves fuel
- Details
-
June 12, 2022
-
Written by Jason Hance
The most common cause of the fall in the fluid level in the Peugeot 206 automatic transmission is the leakproofness of the power train on the left side. The dashboard must flash two LEDs at the same time
- Details
-
June 08, 2022
-
Written by Jason Hance
Peugeot's owners are often diagnosed with error P0006. At the same time, ACPR often goes into emergency mode. This is an engineering defect in hydraulics to operate an AL-4 automatic gearbox
- Details
-
June 05, 2022
-
Written by Jason Hance
The initialization refers to the "training" of the executive clutch mechanism of 2-Tronic on Peugeot 207, which once again forces the box to "feel" the extreme positions, taking into account the wear of the clutch, or after resetting the settings that occurred for some reason
- Details
-
June 01, 2022
-
Written by Jason Hance
If there are no errors on the Peugeot 207 display associated with the work of the RSCs, the clutch of the clutch shall be reduced by the wear and tear of the chaining;-Rear gear is reduced;-Reversing vibration:-vibration at the beginning of the movement