- Details
-
January 25, 2023
-
Written by Jason Hance
Before you start, you should make sure that the light in your car is turned off. For more safety, you can unplug a minute tick from the battery .The first thing to do is to separate the lamp-lamp from its hull, with the flat-blade screwdriver
- Details
-
January 24, 2023
-
Written by Jason Hance
The Kia Cerato 2 lamps in the front lamps are burned quite often. To remove them, remove the headlamp. It's not hard to do. Just open the hood and spin two bolts, holding the headlight. They are located on top of the lamp, on the edges
- Details
-
January 23, 2023
-
Written by Jason Hance
To replace the front fog lamp and rear door lamp in the Kia Serato 2, open the trunk lid, looser the bolt, secure the cover to open the lamp, and remove the cover
- Details
-
January 22, 2023
-
Written by Jason Hance
This function is designed to prevent battery discharge in KIA Rio III. The system automatically shuts off the outdoor lighting when the driver pulls the key from the ignition (stop the engine with the electronic key) and opens the door for his or her part
- Details
-
January 20, 2023
-
Written by Jason Hance
To replace the passing lamp in Kiia Río 3, the following steps must be taken: 1. Rotate the shell counterclockwise at the rear of the headlamp 2. Disconnect the connector from the headlight by pushing the connector and pulling it back 3
- Details
-
January 19, 2023
-
Written by Jason Hance
If a lamp is burned in one of the external lights in the IOC Rio, it must be replaced. When selecting a lamp, it is necessary to orient, first of all, to the manufacturers ' recommendations and the types of lamps that are installed in the KIA Rio III
- Details
-
January 18, 2023
-
Written by Jason Hance
If you choose to replace the battery in the RIO 3, you need to know the battery settings installed on the car before you send it to the auto shop. KIA Rio III has the following characteristics: Unlimited Power ROCKET MF 48-23GL 12V RC: 92 MIN CCA:550A. Capacity-48A
- Details
-
January 17, 2023
-
Written by Jason Hance
The ignition of a light bulb in the passenger compartment at the opening of the KIA Sorento II doors is not available. However, you can install the switch on your own. To do this, you need to unattach and remove the two smores. Three wires are suitable for the plane
- Details
-
January 15, 2023
-
Written by Jason Hance
The KIA Sorteno II rear lamps are held on two screws for a Phillips screwdriver and two rails, which are fixed in plastic groans on the body.
- Details
-
January 14, 2023
-
Written by Jason Hance
One of the most logical options is to connect the video rector to the KIA Sorento II Lounge.To connect, you must do the following: 1. Remove the interior of the passenger compartment with the front screwdriver in the emigame2