Electrical equipment

On the headlights of this model there is a protective coating which, over time, starts to be washed away from not too careful, and then the rubberies become more of the long stay of the car in the sun. The patient "is treated" by means of specialized means.

If there is a power outage in the trunk of the boot, the most likely cause is a failure of the lock actuator. It is also most often made in the wiring harness, which comes from the door to the body. This is a problem that is better addressed to an electro

Most likely a non-return valve is a common problem on the Honda Jazz. To clean it, you need to lift the fifth door and find the connector (there is an arrow) that leads to the washer

To replace the position lamp with the Hyundai Accent battery, it is not necessary to turn off the battery. The lamp holder is secured by the latch that is to be pressed. After this, the bullet must be checked counterclockwise and pulled out

You must disconnect the wire first. Then we need to remove the rubber sealant by pulling in two "ears". The lamp itself is mounted in the headlamp with a metal paper clip, which is fixed when its edge is inserted into the paz in the lamp body

Depending on where the Hyundai Accent fog lamps are made, different types of lamps may be installed

Battery dimensions: 207 mm (length) x 175 mm (width) x 190 mm (height)

Headlamps at Hyundai Accent have plastic optics. It is therefore permissible to use only the lamps for a given type of headlamp, 55 /60W (dipped/long). Otherwise, the lamps can melt plastic optics

There are several ways in which this problem can be resolved in principle. The easiest but the most expensive is to buy new watches and replace them. The original clock will cost about one and a half thousand rubles.

This connector is used to attach a sensor that signals when the driver's seat belt is not fastened. The dashboard has a corresponding icon. Hyundai Accent is not connected to the Hyundai Accent