Electrical equipment

Details

Written by: Jason Hance

Also available:

Created: 14 June 2023

Replacement of the lamps will require a front and a Phillips screwdriver and a tweezers to remove lamps. The first thing to do is to remove the filler panel. To do this, you have to lower the steering column and twist 2 smores at the top of the filler

Details

Written by: Jason Hance

Also available:

Created: 13 June 2023

The removal of the airbag at Audi 100 P4 is a dangerous procedure, so it needs to be carried out with precision. Procedure: Disconnect the battery

Details

Written by: Jason Hance

Also available:

Created: 13 June 2023

A flat-blade screwdriver and cotton gloves are required to replace lamps. There are fillers on the rear of the headlights; they need to be removed by checking the left. Behind the pluffs are plastic arrowheads of passing lamps and position lamps

Details

Written by: Jason Hance

Also available:

Created: 13 June 2023

Changes in lamps for Aodi 100 P-4: Middle light H7, 55 Vt.a Light-N7, 55 B. Front fog lamp-21 W. Rear direction-indicator lamp-21 W. Stop lamps-21 W

Details

Written by: Jason Hance

Also available:

Created: 12 June 2023

If an attempt is made to run the engine starter, the control unit or the reel switch will necessarily be damaged if a high voltage cable is removed from the Aodi 100 C4

Details

Written by: Jason Hance

Also available:

Created: 12 June 2023

To remove the heating buttons of the seats, you need to raise the central tunnel. Remove the clip, which is in the passenger's legs, and unclip the nut by 10 in the driver's legs. Lift the rubber mat in the back of the cup holder and tighten the bolts to 10.

Details

Written by: Jason Hance

Also available:

Created: 12 June 2023

The Audi 100 fuse box is located under the cover on the left side of the dashboard (numbered from upper left to bottom): driving beam headlamp (10 A) .driving beam headlamp (10 A) .right passing lamp + right lamp correction lamp (10 A)

Details

Written by: Jason Hance

Also available:

Created: 11 June 2023

Corrective alignment of the fuel level sensor located in the Aodi 100 4th generation gas tank should be done with the help of special calibration resistors to be used in place of the sensor

Details

Written by: Jason Hance

Also available:

Created: 11 June 2023

In rainy or snowy weather, mirrors are often covered with drops of water or ice crusts. This greatly complicates the review, and at night it is simply disoriating the driver. The solution is to supply the heating mirrors.

Details

Written by: Jason Hance

Also available:

Created: 10 June 2023

The brake lights switch on the Studio 100 4th generation has a slightly higher brake pedal. To adjust his position, do the following: Take off the shelf below the panel.