Replacement of the lamps will require a front and a Phillips screwdriver and a tweezers to remove lamps. The first thing to do is to remove the filler panel. To do this, you need to lower the steering column and roll the 2 smores at the top of the filler. Then you need to pull and free the top of the panel, and then the bottom. Next, disconnect the connector on the onboard computer. You can now remove the view itself. There are four smores at the top. You only need to spin the ones that are closer to the center. Bottom of the bottom, you need to untwist the two. 5 light bulbs are located on the rear of the panel. Two are covered by the speedometer, two are a tachometer, and one is a fuel flow sensor. The rest of the lamps are light thanks to the diodes that they pay. The amps with cartridges are taken with tweepers. To do this, you need to rotate them counterclockwise. The assembly after the replacement of the lamps is reversed.
