Electrical equipment

Details

Written by: Jason Hance

Also available:

Created: 09 July 2023

The simplest solution to this problem is to ride the Hyundai Accent with the lights on, until the moisture is evaporating. If this does not work, it is necessary to remove the headlamp and check it for the presence of bears and cracks

Details

Written by: Jason Hance

Also available:

Created: 08 July 2023

The reason for this sound, which is produced by the proofreader of headlamps, is caused by the excessive amount of factory grease in the regulator, which causes the contact to disappear. To fix the problem, first thing you need to pull out the driver's driver's license is to open up, pull up

Details

Written by: Jason Hance

Also available:

Created: 07 July 2023

It will require a front and back screwdriver to remove the plug. First of all, it is necessary to remove the lens of the plafe by a screwdriver. The next steps are to remove the two screws that secure the plug-in, release the retainers, and remove the plug-in.

Details

Written by: Jason Hance

Also available:

Created: 06 July 2023

To clear the cigarette lighter, you will need to remove the central console. To do this, you need to roll out the carers at the bottom of the coaster that is located in the console. The next step is to untwist the lever arm of the PPC and to understand the parking brake lever up

Details

Written by: Jason Hance

Also available:

Created: 04 July 2023

In the normal structure of Getz, the liquid dries from the washer washer hose, when there is not enough liquid in the tank, and is constantly withdrawing from the back glass washer. These drawbacks can be remediate by inserting the valves into the computer heater

Details

Written by: Jason Hance

Also available:

Created: 03 July 2023

Not all cars have the automatic lowering function and the lifting of the glass for the driver's door. Many have only the stack walk down

Details

Written by: Jason Hance

Also available:

Created: 02 July 2023

Take a sheet of A4 paper and fold it in half. Insert it with a short part in the upper stub of the magnet in the middle. Locate the two front screwdrivers and insert them between the sheet and the blank filler at a distance of 1 cm. from the edge of the sheet. Gently lift both screwdrivers

Details

Written by: Jason Hance

Also available:

Created: 01 July 2023

Goetz has a problem with a speedometer. They are expressed in the wrong evidence of the speedometer and the strange noises from the area of the dashboard. The tachometer and the fuel level indicator are operating normally. This normally occurs at speeds above 80 km/h

Details

Written by: Jason Hance

Also available:

Created: 29 June 2023

The failure of the sound signal is a common problem for Goetz. In this case, the horn continues to function when ignition is off and when the ignition is switched on again. Over time, it can stop working independently of the ignition

Details

Written by: Jason Hance

Also available:

Created: 28 June 2023

Many Goettsev has, over time, stopped working as wipers. The reason is quite banal-the axis of the leash and the motor is simply not coping with the resistance. The repairs are quite simple.