Electrical equipment

To replace the front fog lamp on the Honda Civil 8: Remove the front fog lamp. Then remove the front bumper front fog lamp, removing the front fog-lamp screw fastening

To replace the top stop lamp on the Honda Civil 8: Open the trunk lid. Disconnect the "2P" connector, then turn the lamp holder by 45 degrees counterclockwise, and remove the lamp. The power of the stop lamp is 21 watts

To replace the internal rear lamp on the Honda Civil 8: Open the boot lid and remove the rear-registration-plate frame. Then detach the connector caps of the internal rear lamp

To replace the back blinkers at the Honda Civil 8, dismantle the rear bumper. Then disconnect the rear lamp connector. Lamp power: stop lamps-21 W; rear position lamps-5 W; rear direction indicator lamp: 21 W

The 3rd generation Honda of the 3rd generation vehicle is equipped with a very useful function-automatic switching of the passing beam at engine start. This is especially relevant for forgetful drivers who forget to turn on the passing beam at the beginning of the movement

1. Turn on the ignition at Honda CR-V III, turning the key into the "ON" position. 2. Omit the driver's (or passenger) driving window down to the point of the driver's driving unit of the driver's window slide 3. Open the driver's door.

It is not uncommon for the driver to be in a situation when the lock is closed and the battery is seated. To open the bonnet lock at the Honda CR-V III, the plastic panel of the fuse box, located below the steering column, must be removed

In order to replace the burnt lamp in the third generation of the third generation, the lamp must be removed. He's hanging on two bolts hidden behind the pluits. The cap of the burned lamp shall be rotated 45 degrees counterclockwise and remove the lamp out of the socket

To replace the driving beam at Honda CR-V III, remove the plastic skin by turning it counterclockwise, disconnect the connector by pushing the tab on the retainer, rotate the lamp by a quarter of the rotation counterclockwise, and remove it

The overheating of the button and the VSA switch occurs because of the filament lamps, so heating is inevitable. LEDs are used to highlight other LEDs on the Honda Jazz