Electrical equipment

The shale, which is located under the air supply adjustment knobs, is designed for the recycling of air in the salon (left position) or by air intake from the street (right position). The white band of the gas regulator on the handle does not illuminates

The installation will require the VAZ-2110 blinkers and the gaskets for them, as well as the following tools: a screwdriver with a flat sash, a grating and a knife. Using a thin screwdriver, push the metal peter-place of the rotation

The windshield wiper operation is not on all Gatz. But you can install it. Need to replace wiper control lever

We need to buy programmable relays of glass cleaner from domestic cars. 723.3777-01, 724.3777-01, 524.3777-01, 39.3777-01, etc. -options are many. The configuration shows that the relays may vary, but the markings and the number of contacts are always the same

Many of the owners of the destylinogol version of Getz have found that electrical appliances do not operate from the manufacturer's steamer. The only option is to replace the sturgeon with a 12-volt outlet. It is best to install the original Hyundai power outlet

Sometimes you might want to enter code in a regular magnet. For example, if you are working to remove a battery, you must enter a code after it has been installed on the site. Step by step: 1. Using buttons 1, 2, 3, 4 with four characters

Gently remove the blank filler. Then remove the protective film from the magnets and the so-called "sled". If the magnets are freely mounted and are part of the regular sled, they should simply be inserted and sealed

Maximum permissible battery dimensions for Goetz-207x175x190, capacity-55 or 60 Acha

Hyundai Getz (s) do not turn off themselves after the ignition, the car does not extingule them and after some time, like many others. That's why there's a great possibility that the battery will sit down. However, the system can be improved

To replace the lamps, remove the back door. It is holding on four latches, two pistons and four smores. The next one is to remove the contact from the lamp holder. It's holding on to the latch. The cartridge itself needs to be pulled at 45 degrees counterclockwise and pull