We need to buy a programmable relay of the windshield wiper from domestic cars.
723.3777-01, 724.3777-01, 524.3777-01, 39.3777-01, etc. -options are many. The configuration shows that the relays may vary, but the markings and the number of contacts are always the same. It is possible to make a noise insulation to solve the problem of clicking the relays in the passenger compartment: to make a form of paper, fill it with a sealant, and by first inserting the wires in the relay, carefully put them in a trout with a sealant. We need to cut things with scissors when the sealants are hermetically closed. The installation will require the following tools: cusages, a plush screwdriver, a box cutter, and a fence.
Remove the cell battery. Remove the filler pad under the handlebars. To do this, remove the three screws that secure it and rotate the steering wheel/left. Disconnect the pad in 10 connectors on the right handlebars from the connector. Plug or clip the wire in the following sequence:
1 is a contact with the black wire, there are 31 relay contacts, 6 contacts with red wire, 15 contacts, 8 contacts with orange wire, 31b contact, 9 contact with pink wire, and 86 contacts. Cut the tenth gray wire. 10-contact with a gray wire cut from the pad, J contact.
10-contact with a grey cut wire from the tourniquet with the contact of an additional relay. Isolate the wires. Place the pad on the right side of the rudder and push the relay between the wiring harness under the steering column. Secure it with all the ropes. Secure the plastic decorative lining to the wheel.
