Sometimes you might want to enter code in a regular magnet. For example, if you are working to remove a battery, you must enter a code after it has been installed on the site. Step input:
1. Using buttons 1, 2, 3, 4 with four characters. Click on each button as many times as you want in your code. For example, if the code is 3333, press each button three times.
2. The "5" button is used as a memory button. Click it after you enter the code.
You must enter the code very carefully-you only have three attempts. After the introduction, wait about an hour.
Code reader:
1. Turn on the ignition and feed the radio.
2. Squeeze the SW button for approximately 5 seconds, and then turn off the power to the radio.
3. Then press the SW button 4 times and turn on the radio.
4. The following code values are displayed: 2 4 8 16 32 64 128 256 512. Press the "4" button and the main radio button. The code will be out. The digits will be underlined-they match the digits. Set these numbers. 1 + 2 + 8 + 32 + 512 = 555. I mean, I'll add one more. Getting some numbers. Now we have to divide it by 6 until the balance is less than 6. Don't forget to write down the rest. 555: 6 = 92 remainder 3; 92: 6 = 15 balance 2; 15: 6 = 2 balance 3. Record the remainder in the sequence we obtained: 3 2 3. Now the last private place ahead of all the numbers. It's 2323. Each digit is now added by one. It's 3434. That's the code.
