To remove the heating buttons of the seats, you need to raise the central tunnel. Remove the clip, which is in the passenger's legs, and unclip the nut by 10 in the driver's legs. Lift the rubber mat in the back of the cup holder and tighten the bolt to 10. Lift the handbrake up to the top.
To remove the tunnel, put your fist through the gearbox and the second hand, pull the tunnel up behind the back cup holder. It will be free from the characteristic click. Disconnect the wires from the buttons through the hatch of the box and lift the tunnel vertically. Remove the heating buttons. Push the screwdriver to release the buttons on the sides of the button, and push the button up. Remove the cartridge clockwise for five minutes. The lamp is wrapped up in contact with the cartridge.
The shape and size of the diode are very similar to the regular light bulbs. The light emitting diodes can be a little thicker than contacts at the light bulb. It is necessary to expand the holes under the foot of the LED in the cartridge with a hot needle, and then the legs of the LED will be easily wrapped. Before installing the buttons in the tunnel, connect them to the onboard network and check the polarity of the diodes. If the diode does not burn, move the cartridge 180 degrees and the lamp is burning. Don't forget to connect the wires to the buttons before you put the tunnel in place.
