To install the headlights on the Honda Civil 8 4d, you must: To remove the plastic sidewall on the side of the driver, remove the plastic sidewall. Then remove the mat and in the six-pin connector of the control unit (a gray box located between the fuse box under the panel and the motor shield) and replace the yellow wire with the new wire for the headlight washer (sensory, dual-contact).Connect the connector to the control unit of the bleach. Then, bring the new wire to the "No 1" button on the fan-box button. Connect the mass to the terminals of the lamp "No. 2". To verify the operation of the headlamp-beater's button, turn on the passing beam, turn on the ignition key, and press the button.
- Dismantling the lower bezel on the driver's side by removing the plastic sidewall and unscrewing one side of the side.
- Then remove the mat and the six-pin connector of the control unit (a gray box located between the fuse box under the panel and the motor panel) to replace the yellow wire with the new wire for the headlight washer (sensory, dual-contact).
- Attach a connector to the control unit of the washer.
- Then, remove the new wire to the lamp-unit button and plug in "No. 1".
- Attach mass to "No. 2".
- To test the operation of the headlamp-beaker's button, turn on the passing beam, rotate the ignition key, and press the button.
After this modification, the headlight washer is not activated when the headlamps are switched ON, but switched on only when the passing beam is switched on from the button.
