- It is prohibited to turn on the lights of the central switch until the full installation of the gas-filled HID lamps into its cartridges and until the end of the assembly of the headlamps.
- To avoid shock hazards, do not work with wet-hand hosts, in conditions of humidity, rain or snow, near spraying system.
- It is not recommended to touch the lamps with bare hands to avoid contamination of the lamp.
- Do not disassemble the inverter and incinerators.
- Do not connect the gas-filled lamp to any power source other than the motor vehicle.
- Turn off lights on the main switch.
- Disable the KB and remove it to access the lamp on the left.
- Rotate the rack-mounting bolt by using the T20 special end key, rotate the enclosure 45 ° counterclockwise, and remove it from the unit lamp.
- Rotate the lamp holder by 45 ° counterclockwise and remove it from the cap of the lamp.
- Release the lamp, turn the spring tab, and remove the lamp.
- Install a new lamp in the sequence, reverse it.
- Make sure that the bulbs in the cap are the same as the headlights.
- After the PSC has been connected, enter the audio system codes and configure the radio receiver at the pre-configuration station.
To replace the HID lamps with Honda Civil: