If the windshield wipers have stopped working, many advise them to discard them and replace them immediately. However, not everyone knows that there are several proven "popular" ways that will help to bring the "wipers" back to life and make them wait for a while.
1. Remove the rubber band, dip them in gasoline, then thoroughly rinse the warm water (with soap) and put it in place. It takes just a few minutes to download. After this procedure, the rubber bands will become softer, which means that it will be better to carry out their functions.
2. Spray or smear with silicone grease. The auto shops offer a wide range of such funds, the preferred choice of popular brands. The smear is sold either as a spray or in the form of a tube. In both cases, it is quite simple to put a little silicon on the rubber band.
3. Wet the rag of White Spirits and sprinkles tobacco from cigarettes-a thoroughly rubbering rubber band. White spirit is one of the products of the oil distillation, a soft oily liquid. His dignity is that he not only degreasing the surface, but also smear it. There is one significant disadvantage-it evaporates too quickly. The tobacco function in this case is more likely to be a shamanism, as it is difficult to imagine from a rational point of view. To put a rag around a cloth about the same thing that doesn't give a damn about the worm before you throw the bait in the water. However, faith in the miraculous properties of some asnopoly sometimes helps more than a real medicine.
4. Hold the sobers for half an hour in hot water. In this case, apparently also in degreasing. The hot water will destroy the fat of the fat layer, which will increase their ability to clean the water and the dirt from the glass. For efficient use of the brushes, this will only be sufficient for a short time, so it is better to combine this method with one of the methods listed above.
More about "resuscitation" and replacement of the wiper blade can be read here.