In the event of a Nissan Teana waiver, it is generally necessary to replace the control unit with the beaner switches. But it is possible to try to restore the work of the caretappers on their own. To do this: Scrolling two samoras behind the wheel and remove the control unit. You also need to carefully detach the latches and unplug the wire. Then we remove the protective cover from which the circuit board is located. Detach the screws and the latches that hold the card and gently lift it up so that they do not fall into contact. In places where the wiper switches refer to the blade's operation switch, there may be dirt or rust. These locations on board need to be cleaned and lubricate with conductive grease. The contact of the chivalles can be a little bit off.
- Scrolling two samoras behind the wheel and remove the control unit. Before you do this, you must carefully detach the latches and unplug the wire.
- Then we remove the protective cover under which the board is located.
- Undetach the screws and latches that hold the card and gently lift it up so that no contact is disconnected.
- In places where the contacts from the wiper switches refer to fees, there may be dirt or rust. These locations on board need to be cleaned and lubricate with conductive grease. The contact of the chivalles can be a little bit off.