You can use the protected LED SMD 5050, red color, 60 diodes per meter. The GTC front door is suitable for a 85 cm.
For the connection, acoustic wires shall be used, each with a length of approximately 2 m. The wires shall be attached to the tape and the connection place insulated with a shrink tube. You can use a thermal adhesive or a sealant for insulation to keep the johs in place.
The door should be thoroughly cleaned in the area of the label on the LED tape and the degreasing. The wire can be used at the bottom of the door, with plastic fastenings on the gfra, then on the front stoval rack, further below the ceiling plating to the ceiling of the light. The phone must be removed.
Then, disconnect the connector that is connected to the illuminating light. This will require two wires from the whole tequier: the grey wire is a plus, the black wire is a minus. It is necessary to connect according to the polarity of LED tape: plus to the plus, minus to minus.