To set the cruise control rate on Mitsubishi Padero 4, you need to do the following:
1) Push the ON/OFF push button on the handlebar. The CRUISE lamp must be lit. If it is not, then press ON/OFF again.
2) Increase the speed to the desired speed and press the COAST SET button.
(3) The vehicle will continue to move at a specified speed.
4) To increase the specified speed, press the ACC RES button and hold until the correct speed is reached. Short-term pressure increases speed by 1.6 km/h. You can also use the COAST SET button to get the auto-pedal off the car and press the COST SET button to get the new speed.
5) Speed reduction takes place in the same way, only to replace the ACC RES button by pressing COAST SET, and instead of pedal gas is the brake pedal.