How to change the inter-service interval in the Mitsubishi's onboard computer

To change the interservice interval in the on-board ASX Mitsubisch Machine, you must do the following: Turn off the ignition. Press the INFO button until the display runs out and the balance of the time until the next TED button hold the INFO button about 2 to 3 seconds before the sound. Release the INFO.Replay button 2-3 three more times. The display will display a combination of EU10 (this is an interservice interval of 15,000 km) After the arrival of EU10 three times press INFO.If you have all done correctly, the numbers and letters on the display will blink-this means that you entered the programming mode of the interservice interval.

1. Turn off the ignition.
2. Press the INFO button until the display starts running and the rest of the time to the nearest DR.
3. Then, hold the INFO button for about 2 to 3 seconds before the sound. Release the INFO button.
4. Repeat paragraphs 2 to 3 three more times. The display will display a combination of EU10 (this is the interservice interval of 15,000 km)
5. When the EU10 has been set up three times, press INFO.
6. If you have all done correctly, the numbers and letters on the display will blink, which means that you entered the interservice interval programming mode.
7. Pressing INFO (short, not more than 1 to 2 seconds per click), report to the GCC interval.
8. Long-click INFO (3-4 seconds) of the GCC interval.