On Lifan Solano, it is possible to connect the far headlights to daytime running lamps. Since the light is usually used less frequently, it will reduce the frequency of the lamp. The lamp's light will be about 40% and it will be heated. In addition, the rear position lamps will not be illumated, thus allowing the moving machines to see the stop lamp more clearly. To connect the driving beam to DRL, you must do the following: Purchase a DRL controller.
- Purchase a DRL controller.
- Set it into a fuse box in the engine compartment.
- Remove the battery, the air filter body, and the fuse box of the engine compartment. You can also remove adsorber for your convenience.
- Remove the speed sensor connector and find three wires-black (mass), blue ("+") and orange (data).
- The orange wire is used to connect the white wire to the controller.
- A yellow line of controller is connected to a black with a white stripe in the fuse box, which leads from the ignition locking system to the K1.
- The blue line of the controller is connected to the green wire leading to the K12 relay.
- Controller Black ("-") Connect to the body under the battery.
- Yellow controller ("+") Connecting to the K13 relay (pink with a green stripe).
- A red wire from the controller is connected to the main-bus bolt.