In order to replace the driving lamps and the position lamps, it is not necessary to remove the headlamp to replace the xenon-new passing beam headlamps, the headlamp shall have to be removed.
You need the following lamps:
- The passing beam is equipped with a cap DS2
- Driving beam-L3
- Overall Lights-w5w
- Front fog lamps-HB4
In order to remove the headlamp, the upper edge of the front bumper should be detached and slightly forward.
In order to remove the headlamp, the front bumper should be removed (or removed from the upper end corners). If the lamps are to be replaced in front fog lamps, the bumper will have to be completely removed.
The headlamp shall be secured by two bolts at the top (immediately visible when the hood is open), one bolt on the wing (under the bumper) and one latching bolt positioned under the driving lamp.
After all the creepages are lifted, the headlight just needs to pull it off and take it off.
To remove the gauges and the main-beam lamp, it is sufficient to turn it counterclockwise. The Xenon's passing lamp is under the cover. The lid needs to be removed. There is a metal slot under the cover. He needs to be turned and pulled out. The only steps to be taken are to remove the moustache of the lamp fastening and remove it. The installation is done in reverse order.
