It's quite simple to reset the control unit in the Hover. You need to warm the engine, turn on the dipped-beam headlamps and the front fog lamps, shut off the engine without turning off the headlights and the anti-manslaughter. Next, you need to turn off the battery for about 30 seconds. Then we need to install the cell, start the engine, wait for the back to idle, increase the turnover to 2 500-3000 (all this time of the headlamp shall burn).
Then we need to turn off the ignition and remove the key from the ignition. If everything has been done correctly, from under the bonnet, the clickable clicking will be heard during the throttle calibration.
It is useful to do so when changing the spark plugs and cables or if they accidentally fill with bad gasoline.
