Procedure for the replacement of the stop-signal lamp at A4, Generation 3: At the wheel of the tie breaker, first push back one of the fastenings, then lift the remaining two bolts at the bottom of the cover plate. Let' s remove the bezel by pulling the plug on it. Pull it back to itself. Disconnect the pad from the backlight. Detach the connector from the "frog".
- Under the steering wheel, find the tie breaker-switch-first push one of the fastenings, then remove the second anchorage.
- Scrolling the remaining two bolts at the bottom of the docking bar.
- I'm going to unwind the bolts in the area of the fuse box.
- Take off the panel by pulling it on.
- Disconnect the pad from the backlight bulb.
- Detach the connector on the diagnostic connector.
- Lean the frog connector, turn it counterclockwise, and pull it out.
- The new frog is in reverse sequence.
