If a Citroen C4 car in the upper layer of the stone is thrown into the windshield, it can be made. To prevent further development of cracks and other damage, it is possible to pre-drill deep holes at the ends of cracks. The beginning of the injection is as necessary from the cleaning and leveling of the edges. Then, with the injection of the injection probe, you can close the place of the light transmitting tape. Then remove the ultraviolet light. Remove the excess polymer with a sharp blade and polish the surface of the glass with a polymeric liquid.
- To prevent further development of cracks and other damage, you can pre-drill holes at the ends of the cracks.
- Start the incorporation as necessary from the cleaning and alignment of the edge as it is.
- Then, with the help of injection, special polymeric composition shall be injected under pressure.
- After injection of the convoy, close the place of damage of the light transmitting film.
- Install the UV lamp and solidiom the polymer composition of its light.
- Then remove the film, remove the excess polymer with the sharp blade, and polish the surface of the glass with the polishing fluid.