Lifan Smiley's Salon lamp (S10W) is characterized by low light and relatively large energy consumption. Alternatively, you can install LED ribbon on your own. To do this, you need to:
- Use the screwdriver to remove the background lens.
- Then remove the lamp and remove the two retaining screws of the plug-in.
- Drag and drop the enclosure.
- Purchase a self-adhesive tape of about 25 cm long (type 12V 5050 60LED).
- You can get on one side of the "+" and "-" wires. On the other side of the wires, the ring terminals are stuck.
- On the side of the shell, adhesive tape and apply a foil on the inside of the shell to serve as a reflector.
- Have a cage under the smores from the back of the headscarf. Minusian needs to be turned on by the connector.
- Connect the connector to the background and verify the operation.
- Set plaid to location
Alternatively, you can use a side LED lamp with a radiator instead of light-emitting diode.
After the replacement, the lighting of the passenger compartment will be brighter with less current.
