To set the threshold highlighting of Lifan Smiley, which will be lit when the doors are opened, you must:
- Pull two wires under each side of the car.
- Install the illuminated linings on the threshold and connect them to wires in parallel.
- Connect the wires to the HPC unit (located behind the panel under the steering column and under the fuse box). You need to connect the wire with a 2A fuse to any black and blue wire that goes to the large connector of the unit. Minus the red wire of the small HPC unit.
If you are using this diagram, all the fillers will be lit when you open at least one door. In order for the lining to be lit only by the door that opens, it is necessary to make a dilation for the normal operation of the alarm and the headscarf.
