The replacement shall be carried out on the fully cold motor of the following pattern:
(1) Remove the protection of the engine and the lower spray;
(2) Unplug the cork of the expansion bass.
(3) A capacity of at least 6.5 litres at the inlet of the heat sink is no less than 6.5 litres.
(4) The discharge of the discharge valve by 2 to 3 revolution and the merging of the OJ.
(5) Put the receptacle under the drain hole on the left side of the cylinder block.
(6) The discharge of the discharge valve by 2 to 3 revolution and the residual of the antifreeze.
(7) Tightback the cork back (the radiator cap, the lock of the radiator, the keylock with a torque of 12.7 Nm).
8) A distilled water for washing the system and start the engine.
9) Power motor when the fan is turned on and water is poured.
10) Repeat the washing procedure until the water is clean.
11) Pour new antifreeze to the level of the vapour pipe.
(12) Wet and muel the engine several times, so that the air is completely out of the system, while the preheat of the OJ is up to the level of the vapour pipe.
13) The deaf engine, let it cool and make the antifreeze to FULL.
(14) Enlock the cork of the expansion bacht, put on the place of protection and spray.
