To replace, you will need to: 3.5 liters of motor oil with viscosity 5W30 ,oil filter, the key for removing the oil filter (32100-10605), 14 mm head for the dismantling of the cork plug, and the washers for the cork plug (Plug Gasket Toyota Part: 90430-12028). Before you start working, you have to set up a flat site, if there is a hole or an overpass, and then you have to turn off the cork of the drain hole and wait for the engine oil to be replaced by the oil. Then you have to turn off the oil filter and wait for the hole in the oil hole. Then you need to pour the oil into the new oil filter. fresh oil, closing the filler cap.
- 3.5 litre of engine oil with viscosity 5W30,
- oil filter,
- The key to remove the oil filter (32100-10605)
- 14 mm head for the removal of the cork,
- The plug washer (Plug Gasket Toyota Part: 90430-12028).
- Before you start working, the car needs to be set on a flat site, if there is a hole or an overpass-even better.
- Then it is necessary to remove the cork of the drain cork and wait for the engine oil to be replaced.
- A hole in each oil substitution must be replaced.
- The next task is to twist the oil filter and wait for the oil to be removed from the resulting hole.
- Then open the lid of the filler neck and wait a little more, and the oil can continue to flow.
- After that, you need to pour the oil into the new oil filter.
- To finish the cork with the new Cheyba.
- Get three and a half a gallon of fresh oil.
- Close the filler cap.
