The procedure for replacing the coolant with the Toyota Camry VII is as follows:

(1) The replacement shall be made on the cold motor. First, it is necessary to remove the protection of the engine, to spin off the cork in the radiator and the cylinder block, and to drain the liquid to a pre-cooked capacity of at least 10 litres.

(2) Clear and install the cork-plug.

(3) Remove the air duct and the air purifier. Disconnect the heater hose.

(4) Fill the new liquid at a rate of not more than 2 litres per minute. When the liquid starts to flow from the heater hose, it needs to be installed and filled.

(5) Install air duct and air purifier.

(6) Heat up the engine, shut it down, and wait for the engine to cool.

(7) To rule the system with a liquid.




Add comment

Security code
Refresh